how to change a fuel filter

by:Ultimate     2020-11-27
Removing the old fuel filter is usually connected to the fuel line in two places, that is, the intake side and the exhaust side, and the entire assembly is fixed in place with the mounting bracket.
Your car\'s fuel filter can be located anywhere in the fuel line, meaning it can be located at the back of the car near the tank or under the hood close to the engine.
After finding the filter, you need to relieve the pressure in the fuel line;
Otherwise, the fuel will be spewing everywhere, causing potential safety hazards and huge confusion in the process.
You can relieve fuel pressure in a number of different ways, but a common way is to remove the fuse of the fuel pump and then run the engine until the engine dies.
The next step is to disconnect the negative pole of the car\'s battery to minimize the chance of sparks igniting gas smoke.
Next, check the fuel filter to determine how the fuel line is connected.
In some cases, the clip fixes the fuel line to the filter.
In other cases, the \"Banjo bolt\" or other special fasteners connect the fuel line to the filter.
Make sure to pay special attention to any washers or O-
Connect the ring on the component.
While replacing the fuel filter will usually be equipped with new connection hardware, you need to know how everything is combined when you install the new filter.
Before disconnecting the fuel line, wrap the filter with a towel to capture any fuel spilled from the line and filter.
Once the fuel line is disconnected, remove the filter from the mounting bracket and handle it.
Custom message
Chat Online
Chat Online
Chat Online inputting...